Page 1 of 1
Alumaweld boat floor replacement
Posted: Fri Aug 21, 2009 11:34 am
by medic1
So I was bored the other day and decided to replace the floor in my 86 alumaweld. I have one question for those that have done something like this before. What is the best way to secure the floor to the boat? The factory used rivits. As the rivits popped out, the guy that owned the boat before me used screws to hold the floor down. Thanks for the help
RE:Alumaweld boat floor replacement
Posted: Fri Aug 21, 2009 1:52 pm
by G-Man
Stainless steel screws are what secure my deck(floor) to the boat.
RE:Alumaweld boat floor replacement
Posted: Fri Aug 21, 2009 3:56 pm
by hewesfisher
G-Man wrote:Stainless steel screws are what secure my deck(floor) to the boat.
Same way in our Hewescraft.
RE:Alumaweld boat floor replacement
Posted: Fri Aug 21, 2009 4:58 pm
by Easy Limits
Screws are what hold the floor down in my '05 Alumaweld.
RE:Alumaweld boat floor replacement
Posted: Fri Aug 21, 2009 7:41 pm
by medic1
Thanks guys. Thats what I decided to go with, that way I can remove the floor to run the cable for the transducer for the new lowrance in a couple of months