who wants to talk about steelhead??

A place for readers to talk about river fishing in Washington.
Forum rules
Forum Post Guidelines: This Forum is rated “Family Friendly”. Civil discussions are encouraged and welcomed. Name calling, negative, harassing, or threatening comments will be removed and may result in suspension or IP Ban without notice. Please refer to the Terms of Service and Forum Guidelines post for more information. Thank you
User avatar
A9
Rear Admiral One Star
Posts: 3668
Joined: Sun Apr 29, 2007 7:04 pm

RE:who wants to talk about steelhead??

Post by A9 » Thu Oct 18, 2007 4:30 pm

Sky gets good runs because of the Reiter Ponds and the Wallace hatchery, as well as the native fish as well...Eggs works well but it's a messy and tougher way of fishing for them, they are the best high water/dirty water technique by far though...
Don't chase reports...Be the report others chase....

User avatar
Drewp
Commander
Posts: 389
Joined: Sun Apr 29, 2007 4:39 pm
Location: seattle

RE:who wants to talk about steelhead??

Post by Drewp » Thu Oct 18, 2007 5:08 pm

Sam is right. Eggos are some seriously messy beasts. But they do work - the problem I have is rebaiting all the time. Less messy are sandshrimp, but same problem there with rebaiting all the time. I always prefer gear over bait if I can get away with it, so i usually go with a spoon or jig and float.

That being said, after a two seasons with a measurable amount of tries and years subscription to Steelhead Trout Salmon magazine, I'm still 0-fer in the steely department. I'm hoping this winter I'll pop my cherry.
"My fingers smell fishy and I like it."

User avatar
travislikesfishing
Lieutenant
Posts: 251
Joined: Sat Jun 30, 2007 11:29 pm
Location: spokane

RE:who wants to talk about steelhead??

Post by travislikesfishing » Thu Oct 18, 2007 7:20 pm

are u suppose to use bait with blue fox spinners and wiggle warts.??
KEEP UR LINE TIGHT SO U CAN FEEL THE BITE!!!!!

User avatar
A9
Rear Admiral One Star
Posts: 3668
Joined: Sun Apr 29, 2007 7:04 pm

RE:who wants to talk about steelhead??

Post by A9 » Thu Oct 18, 2007 8:07 pm

Nope no bait for spinners/wigglewarts..

You can still scent them....
Don't chase reports...Be the report others chase....

User avatar
Derrick-k
Commander
Posts: 552
Joined: Wed Jun 27, 2007 3:49 pm
Location: kent Wa

RE:who wants to talk about steelhead??

Post by Derrick-k » Thu Oct 18, 2007 8:14 pm

I've seen them bait wiggle warts on north to alaska.

User avatar
A9
Rear Admiral One Star
Posts: 3668
Joined: Sun Apr 29, 2007 7:04 pm

RE:who wants to talk about steelhead??

Post by A9 » Thu Oct 18, 2007 9:59 pm

Really?
I know they wrap kwikfish with sardine wraps, but never seen wigglewarts baited...

As close as you will get to baited "spinners" are spin n glos with a hefty glob of eggs trailering the spin n glow...
Don't chase reports...Be the report others chase....

User avatar
Fisherman_max
Commander
Posts: 573
Joined: Sun Apr 29, 2007 8:24 pm
Location: Vancouver, WA

RE:who wants to talk about steelhead??

Post by Fisherman_max » Thu Oct 18, 2007 10:48 pm

Sam Kafelafish wrote:Really?
I know they wrap kwikfish with sardine wraps, but never seen wigglewarts baited...

As close as you will get to baited "spinners" are spin n glos with a hefty glob of eggs trailering the spin n glow...
speaking of spin n glos has anyone used them in rivers and had success i have a couple nad havent really used them but i really like the action on them but i dont understand how you could get them to sink with out a hunk of lead or somthing or are they a top-water salmon lure?
"If people focused on the important things in life, there would be a shortage of fishing poles"

Max's Video Production


serving Washingtons greatest fishing website since 12/14/07


sending videos soon.

User avatar
A9
Rear Admiral One Star
Posts: 3668
Joined: Sun Apr 29, 2007 7:04 pm

RE:who wants to talk about steelhead??

Post by A9 » Thu Oct 18, 2007 11:47 pm

You definetely use weight for spin n glos to get them down near the bottom...
Don't chase reports...Be the report others chase....

User avatar
the1fishingpro
Lieutenant
Posts: 239
Joined: Tue Aug 21, 2007 1:23 am
Location: Vancouver
Contact:

RE:who wants to talk about steelhead??

Post by the1fishingpro » Fri Oct 19, 2007 1:15 am

Tomorrow Im gonna Try some Steelhead Fishing and Then I'll Come back and let you guys how I did. Maybe even a picture if Im lucky!
If in doubt set the hook!

User avatar
EdmondsBassMan
Warrant Officer
Posts: 152
Joined: Tue Jun 19, 2007 11:13 am
Location: Lynnwood
Contact:

RE:who wants to talk about steelhead??

Post by EdmondsBassMan » Fri Oct 19, 2007 4:00 am

When using eggs is there a special way to attach them? I tried using them the other day and when I casted they went flying off. Also I would bet current will tear them off. So with the jig and float does is the action of the float enough to work the jig or do you kind of jiggle your rod to give action. What is the technique cast up stream and let it drift in the current till it gets down below you then retrieve and repeat. I have the idea down just want to make sure I'm doing it right. I know presentation can make all the difference between catching and not catching.
WORK IS FOR PEOPLE WHO DON'T KNOW HOW TO FISH!

EdmondsBassman AKA Jerz Jay

User avatar
Drewp
Commander
Posts: 389
Joined: Sun Apr 29, 2007 4:39 pm
Location: seattle

RE:who wants to talk about steelhead??

Post by Drewp » Fri Oct 19, 2007 10:41 am

Some egg cures are better than other in terms of staying on the hook. It helps to use scissors to cut through the skeins rather than trying to rip them apart, you get nicer more uniform pieces that are still in good enough chunks to stay on the hook. But, there's not much more than that you can do. There's a lot of re-baiting involved when using bait.

With the jig and float, you're not really going for any "action" persay. It's not at all like jig fishing for bass. Basically, the fish are close to the bottom looking upstream and therefore can see anything the current is bringing to them. So you want to cast upsteam and float the jig through runs where you think fish are holding. You want it to look as natural as possible - drag free drift - meaning it shouldn't seem like you have a line attached to your float. They are close to the bottom, so you want your jig as close to the bottom as you can get. Maybe even bouncing off a rock here and there.
"My fingers smell fishy and I like it."

User avatar
A9
Rear Admiral One Star
Posts: 3668
Joined: Sun Apr 29, 2007 7:04 pm

RE:who wants to talk about steelhead??

Post by A9 » Fri Oct 19, 2007 11:29 am

Adding to what Drewp said, you use slight waves and bumbps in the water to give the jig any action. Meaning the float will go through the drift and any waves will cause the float to rise and fall over the water while going downriver, causing the jig to move a bit underwater in response to the way the float bumps...
Don't chase reports...Be the report others chase....

User avatar
leahcim_dahc
Commander
Posts: 539
Joined: Mon Aug 20, 2007 7:30 pm
Location: Graham, Wa.

RE:who wants to talk about steelhead??

Post by leahcim_dahc » Fri Oct 19, 2007 12:21 pm

EdmondsBassMan wrote:When using eggs is there a special way to attach them?
Might try out putting your egg clusters in a bit of spawn net...it will stay on much longer. Do you tie your own leaders? If you just use the egg clusters by itself tie your leader with an egg loop and put the egg cluster in the loop...usually will stay on for a handful of casts. HTH!

http://www.piscatorialpursuits.com/reso ... erknot.htm


Chad
Chad

America will never be destroyed from the outside. If we falter and lose our freedoms, it will be because we destroyed ourselves. - Abraham Lincoln, 1809-1865

User avatar
the1fishingpro
Lieutenant
Posts: 239
Joined: Tue Aug 21, 2007 1:23 am
Location: Vancouver
Contact:

RE:who wants to talk about steelhead??

Post by the1fishingpro » Fri Oct 19, 2007 12:25 pm

Good going Chad, I was just about to say use an egg loop myself, but u were 1 step ahead! gj buddy!
Last edited by Anonymous on Fri Oct 19, 2007 12:29 pm, edited 1 time in total.
If in doubt set the hook!

User avatar
EdmondsBassMan
Warrant Officer
Posts: 152
Joined: Tue Jun 19, 2007 11:13 am
Location: Lynnwood
Contact:

RE:who wants to talk about steelhead??

Post by EdmondsBassMan » Fri Oct 19, 2007 6:14 pm

Thanks for the info guys! Chad thanks for the link that helps a lot!
WORK IS FOR PEOPLE WHO DON'T KNOW HOW TO FISH!

EdmondsBassman AKA Jerz Jay

User avatar
leahcim_dahc
Commander
Posts: 539
Joined: Mon Aug 20, 2007 7:30 pm
Location: Graham, Wa.

RE:who wants to talk about steelhead??

Post by leahcim_dahc » Fri Oct 19, 2007 6:54 pm

EdmondsBassMan wrote:Chad thanks for the link that helps a lot!
no problem! :thumright

Good luck finding the steelhead, let us know how you get along!


Chad
Chad

America will never be destroyed from the outside. If we falter and lose our freedoms, it will be because we destroyed ourselves. - Abraham Lincoln, 1809-1865

User avatar
jake campbell
Petty Officer
Posts: 90
Joined: Thu May 17, 2007 5:00 pm
Location: Arlington

RE:who wants to talk about steelhead??

Post by jake campbell » Fri Oct 19, 2007 8:17 pm

Got some silvers this year, and a bunch of eggs so i'm ready to drift some for steelhead this winter.

I want to catch a biggun.

User avatar
travislikesfishing
Lieutenant
Posts: 251
Joined: Sat Jun 30, 2007 11:29 pm
Location: spokane

RE:who wants to talk about steelhead??

Post by travislikesfishing » Sat Oct 20, 2007 12:55 am

in all of your opinion what do you think work best for catching steelhead near lower granit dam if you have fished there or near there?
KEEP UR LINE TIGHT SO U CAN FEEL THE BITE!!!!!

User avatar
Derrick-k
Commander
Posts: 552
Joined: Wed Jun 27, 2007 3:49 pm
Location: kent Wa

RE:who wants to talk about steelhead??

Post by Derrick-k » Sat Oct 20, 2007 10:58 am

If I where you I would stick with the slip bobber and a jig tecnique tip it with prawn or sandshrimp. Wiggle warts are mostly for boat fishing.

User avatar
travislikesfishing
Lieutenant
Posts: 251
Joined: Sat Jun 30, 2007 11:29 pm
Location: spokane

RE:who wants to talk about steelhead??

Post by travislikesfishing » Sat Oct 20, 2007 2:10 pm

cant you use blue fox spinners from the shore
KEEP UR LINE TIGHT SO U CAN FEEL THE BITE!!!!!

Post Reply