Hey guys and gals
Im a newby great site
I have a mystery pole Im trying to ID its two butt pieces with a nice screw collet on the end, one is 14" the other 12". I was hoping someone could help me ID these? looks like good quality and will make a nice pole. Here are some pictures. Please let me know what you think it could be.
Thanks Cycle
Mystery take down butt end
-
cyclesurvival
- Angler
- Posts: 2
- Joined: Fri Jul 06, 2012 5:52 pm
Mystery take down butt end
- Attachments
-
- DSC00162.JPG (151.11 KiB) Viewed 2918 times
-
- DSC00161.JPG (148.64 KiB) Viewed 2918 times
-
KitsapJohn
- Petty Officer
- Posts: 12
- Joined: Wed Jul 04, 2012 8:19 am
- Location: Kitsap county / Bremerton
Re: Mystery take down butt end
looks 70s - 80s fenwick but just a guess
Re: Mystery take down butt end
I would go with the older Fenwick ID also. You have the bait casting butt end and a ring type spinning butt end. I used to have a similar rod, mine was a threaded spinning and a threaded bait-casting rig. The ferule seen in the picture should have the business end or the rod bonded in place. As an FYI, when I was a teenager I had bought the rod at a thrift store in Bothell and was not overly impressed with it.
-
cyclesurvival
- Angler
- Posts: 2
- Joined: Fri Jul 06, 2012 5:52 pm
Re: Mystery take down butt end
Thanks guys
I'm still looking no matches so far. Since Im close to some of the best custom rod builders in the NW I think Im going to have a 3 piece rod made with modern materials.
I'm still looking no matches so far. Since Im close to some of the best custom rod builders in the NW I think Im going to have a 3 piece rod made with modern materials.